Koolance ADT-FM002P Manual do Utilizador descarregar pdf

The Koolance ADT-FM002P allows a Molex 4-pin 12V PSU connection to power LED lighting of Koolance INS-FMxx Flow

Meters. It also multiplies the ﬂ ow meter RPM signal to allow it to be read by most fan tachometer headers (such as those found

on ATX motherboards).

The ﬂ ow meter RPM reading is intended to allow fan detection software (including BIOS) to enable the appropriate alarm or

shutdown procedure if the ﬂ ow meter impeller stops rotating. The “RPMs” represent approximate coolant ﬂ ow rate in mL/min,

and not revolutions.

The required connections for ADT-FM002P are illustrated below. CAUTION: Make sure to properly insulate the circuit from

chassis ground, or permanent damage can occur to the circuit and/or ﬂ ow meter.

Koolance ADT-FM002P Installation Guide v1.00

Coolant ﬂ ow meter LED

switch: off, on, pulse

(according to ﬂ ow rate)

Motherboard signal connection

12V 4-pin Molex

power supply connection

Coolant ﬂ ow meter

(sold separately)

Meter liquid ﬂ ow

compensation

(10-13mm & 6mm ID)