Koolance PSU-1000ATX-12N-R Manual do Utilizador descarregar pdf (Página 8)

For most computer cases, the PSU-1000ATX-12N must be installed from inside

the chassis due to its width. If you do not have a Koolance case, please skip to the

next section.

Most Koolance chassis must give up one hard drive cage in order to ﬁ t the PSU-

1000ATX-12N. Begin by removing the screws for this rear drive cage, the top screws

for the front hard drive cage, and the PSU partition wall. Screws are located above

and below the hard drive area.

Remove the PSU partition wall and

rear hard drive bay.

With the top screws of the front

hard drive cage removed, it

should be possible to remove

the rear drive cage by carefully

ﬂ exing the top partition (without

completely removing the front

cage).

1 2 3 4 5 6 7 8 9 10 11 12 13

Sem comentários

Koolance PSU-1000ATX-12N-R Manual do Utilizador Página 8