Koolance EX2-750SL Manual do Utilizador

Protected by U.S. Patents 6,664,627; 6,313,990; 6,234,240; 5,731,954Other Technology Pending U.S. & World-Wide PatentsSuperior Liquid Cooling Sys

5User ManualLED Display PanelTemperature SensorsExos-2 systems can monitor up to 3 temperature sensors (included). The fi rst LED digit indicates which

6Alarm SettingsBy default, the Koolance audio alarm will sound if any sensor reaches 55ºC (131ºF). When the system alarm sounds, the LED temperature w

7User ManualChapter2Connecting Exos-2 Systems

8Positioning the ExosThe Exos is designed to operate in various locations, but it must run upright. Air fi ltration is not possible in all orientations

9User ManualExternal Nozzles & Power CableCut the included 10mm (3/8”) tubing into two segments. You will need to connect each to the Exos’ rear n

10 Connecting Exos-2 SystemsConnecting the Slot AdapterThe Slot Adapter allows the Exos-2 to connect with any ATX computer through an available card

11User ManualInstall the Slot Adapter into any available rear card slot in your computer.Screw the Slot Adapter in place as you would a normal device.

12 Connecting Exos-2 SystemsPower ConnectionThe Exos-2 requires approximately 11-17W from any standard ATX power supply. Since it is adapted interna

13User ManualATX Power SwitchThe ATX “pass through” lead is responsible for shutting off your computer if sensor channel #1 reaches 3ºC (5ºF) above t

14Depending on the cooling blocks (“coolers”) in your Koolance system and nozzle sizes (1/4”, 3/8”, etc.), they may be connected in series, parallel,

iUser ManualThis User Manual is updated regularly. Please be sure to check our support page for a newer version of this guide: www.koolance.com/suppor

15User ManualThe maximum number of coolers allowed in a system will depend upon your specifi c thermal requirements and hose confi guration. It is not u

16Nozzles are designed to attach tightly. If you need to remove a hose for any reason, it may not pull off easily, even after unscrewing the compressi

17User ManualHose LengthsBefore installing your liquid coolers, appropriate lengths of tubing must be cut to connect each device. It is generally easi

18Continue connecting all of your coolers in the system until there are no longer any open tube ends.Liquid CoolersYou should now install the liquid c

19User ManualChapter3Filling & Maintenance

20Once all of the coolers have been con-nected, the system can be fi lled with coolant. The refi ll plug is located on top of the reservoir. Remove the

21User ManualAllow the pumps to run for about 1-5 minutes. When fi ltration has ended, the liquid noise should stop. If the reservoir level becomes sig

22The coolant in your system should be emptied for any of the below reasons. Unless replacing the liquid coolant, it can also be reused.1. To Keep it

23User ManualYour Koolance system is designed to provide years of reliable cooling. To help avoid unnecessary product returns, we have prepared this l

244. After the system has been on for a while, the temperature alarm sounds...Make sure the LED temperature is at or above your preset alarm temperatu

iiWARNING: The Koolance liquid & coolant pack contain chemicals which may be harmful or fatal if swallowed. KEEP THIS AND ALL DANGEROUS CHEMICAL

25User Manual6. My system appears to be leaking fl uid...Since users are allowed to confi gure their own coolers and clamps, it is possible a connection

26Limited WarrantyDisclaimerKoolance Incorporated (“Koolance”) warrants each new Koolance liquid-cooled system (“the system”), against defects in mate

www.koolance.comISO 9001Printed in Korea

iiiUser ManualTable of ContentsIntroduction 1Exos-2 System Diagram ... 4

iv Exos-2 Series Systems: - External Power Cable - Slot Adapter - Rubber foot pads - ATX power jumper wire - refi ll funnel - liquid coolant mixtur

1User ManualChapter1Introduction

2 Congratulations on your purchase of a Koolance system!As the most sophisticated product of its kind, Koolance offers many unique features found now

3User ManualThe heart of a liquid cooling system is the pump. This device pushes liquid through each cooler and into the heat exchanger. Koolance syst

4 IntroductionExos-2 System DiagramReservoir & PumpsRadiator Cooling FansReservoir Refi ll PlugCoolant InletPower ConnectionLED Display PanelRes